Using Orders to Your Advantage
Now that you've read about
the different types of orders, here are 1 some suggestions regarding
their use. The purpose of learning
how to use price orders to
your advantage is obvious. Profitable day trading depends on making every penny
and every poinl count. You must be consistent and frugal in everything you do
Here is a list of dos and don'ts with respect to orders:
ж Try to avoid using
market orders unless absolutely necessary. Markel
orders cost you ticks. If you lose a few ticks getting in and a few ticks
getting out, then you have lost good money, often unnecessarily. There are
many good alternatives to market orders. Some of them have been discussed
previously; others will be discussed later.
ж Don't use MOC
orders. They will cost you ticks, and ticks add up A
few ticks here, a few ticks there - pretty soon it adds up to rea.
money. If you must use such an order, then you are probably better off
selling at the market several minutes before the close than in giving your
broker an MOC order. Again, as far as I'rr concerned an MOC is, most often, a
license to steal.
ж Use stop limit
orders instead of stop orders. In most cases you wil be
filled. If you are concerned about being filled, put a one- oi two-tick limit
on your order.
ж Fill-or-kill orders
can be used to your advantage in several ways. Il
you need to exit or enter a trade and you don't want to wait to find out if
you've been filled, then use an FOK order. You'll get quick feedback, and
you'll probably save money. If you've never used such orders before, then get your
feet wet.
ж Use FOK orders to
test a market. One good way to see how strong or weak a
market may be is to use an FOK order. Here's what I mean: Let's say that June
S&P futures are trading between 406.50 and 406.90. You had a buy signal at
406.50. Trading volume is light. Following the buy signal, prices moved
quickly to 406.90, and you didn't want to chase the market. You are concerned
that the signal might not work this time, because the market fell back quickly
to the original breakout price of 406.50. You are therefore hesitant to buy.
What to do?
Test the market by placing
an FOK order to go long at 406.45 or 406.40, knowing that this is below the
recent range of trades. Your order goes in and you watch the tape. It reads
406.55 when you enter your order. The ticks then go as follows: 406.55 . . .
406.50 . . . 406.53 . . . 406.50 . . . 406.50 .. . 406.45B (your bid) . . .
406.45. You are filled at your bid price. What does this mean about the
character of the market? Most likely this indicates a market that is weak. You
were filled at a low bid, and this means that there are willing sellers. This
characterizes a weak market.
However, consider the same
scenario with a different outcome. You enter your bid at 406.45 FOK. The tape
reads 406.55 when you enter your order. The ticks then go as follows: 406.55 .
. . 406.50 . . . 406.55 . . . 406.50 . . . 406.50 . . . 406.55 . . . 436.55 . .
. 406.60 . . . 406.65 . . . 406.60 . . . 406.55 . . . 406.60 . . . 406.65 . . .
406.70 . . . 406.75 . . . and so on. The market never even comes close to your
bid, and the order is returned killed. What does this mean? It indicates a
market with good demand. It suggests that you had better get on board quickly.
You may even want to use a market order to do so.
Category: Methods of Daytrading
|